Genzler Genzler re/Q Dual Function EQ Pedal
You might also want to connect with us on Facebook, YouTube, Instagram, or by email.
Out of stock
Genzler re/Q Dual Function EQ Pedal
Is a low noise, ALL ANALOG multi-function HIGH PASS FILTER – LOW PASS FILTER and 5 BAND EQ pedal that gives the player complete tonal control over the cut-off of the extreme low and high frequencies, plus 5 bands of peak-dip equalization. The filter section is foot switched independently from the EQ section, and there is additional make-up gain or cut after the EQ for balancing of levels or to act as an additional boost/cut function when the EQ is switched into the signal path.
The Re/Q — DUAL FUNCTION EQUALIZATION pedal, offers 2 specific and separate filter networks, HPF and LPF filters with on/off switching and a 5 band EQ network, with its own on/off switching. And the EQ network provides an EQ Output level of +/- 9dB. This versatile design allows the pedal to be used as a clean boost, and is a great combination with the 4 ON THE FLOOR, CLASSIC BASS OVERDRIVE pedal.
Specs
Knobs
- Low
- This control +-12dB @ 90Hz
- Low Mid
- This control can either +-12dB @ 250Hz
- Mid
- This control can either +-12dB @ 630Hz
- High Mid
- This control can either +-12dB @ 1.3kHz
- High
- This control can either +-12dB @ 2.6kHz
- High Pass (Low Cut) Filter
- This control is a variable frequency low cutoff of the signal into the pedal. Increasing the frequency of this roll-off, reduces the low frequency energy and helps retain the articulation and note definition with higher settings.
- Low Pass (High Cut) Filter
- This control is a variable frequency high cutoff of the signal out of the pedal. Reducing the frequency of this roll-off reduces the high frequency energy in the signal and can mellow out the tone of the signal.
- EQ Output Level
- This controls the level of overall EQ added to the signal @ +/-9dB
Switches
- Filters Footswitch
- Pressing the footswitch alternates the pedal’s operation between BYPASS mode (RED LED) and ACTIVE mode (BLUE LED). No controls on the pedal will function in bypass mode.
- EQ Footswitch
- Pressing the footswitch alternates the pedal’s operation between BYPASS mode (RED LED) and ACTIVE mode (BLUE LED). No controls on the pedal will function in bypass mode.
Power
- Power
- 9VDC-18VDC (low noise type), either polarity (auto-detecting), 40mA max (Power supply not included)
Outputs
- Input
- 1/4" Pedal input, nominally instrument level but can accept line level with the sensitivity switch set low. Input impedance is 1M
- Power Jack
- This pedal contains circuitry that auto-detects both the voltage and polarity of the attached power supply. The pedal will function properly from 9V to 18V, center positive or center negative polarity
- Output
- 1/4" Pedal output, nominally instrument level but can output up to line level with the DRIVE and CLEAN volumes turned up.
Dimensions
- Dimension
- 12,7cm x 10,4cm x 5,9cm
- Weight
- 0,6 kg